Board Size:
    50 to 400mm  (450mm optional)
Pre-Heat Zone Length: 1800mm (1900mm optional)
Pre-Heat Zone Quantity: 2 bottom (topside optional)
Pre-Heat Power: 9kW
Pre-Heat Temperature: ambient to 250C (300C with topside preheater)
Solder Pot Volume: 420kg
Solder Pot Power: 12.6kW
Solder Pot Temperature: ambient to 300°C
Nozzle Design:
    Dual waves with wave heights adjustable from 0 to 10mm each. Low oxidation quantity design. Short distance between the nozzles to avoid temperature decline between the waves.
    : Wave height adjustable from 0 to 10mm. Low oxidation quantity design.
Solder Dregs Qty:     
    <2kg/8h    
Wave Motor:
   2 * 0.75kW, heat resistant    
Wave Height Adjustment: Frequency conversion adjusting
Temperature Control Accuracy: ±1°C
Horizontal Temperature Tolerance: ±3°C
Flux Spraying System: Spray fluxer, made in Japan. PLC control from Mitsubishi.
Fluxer Capacity: 6L
Conveyor Motor: Panasonic
Conveyor Fingers: Double hook titanium fingers; front fixed, back fingers move when conveyor width is adjusted
Conveyor Height: 29.5"(750mm)±0.75"(20mm)
Conveyor Width: 1.2"(30mm)--15.7"(400mm) – 450mm width optional
Conveyor Angle: adjustable from 3° to 7°
Conveying Direction: left to right (right to left optional)
Conveying Speed: 0 to 71”(1800mm)/min
Control: Built-in panel. PC control available.
Surface: Matt finish temperature proof powder coating
Start-Up Power: 23kw
Normal Operation Power: 11kw
Power Requirement: 220V AC 3-phase 60Hz
Compressed Air Requirement: 29 - 43.5psi
Dimensions:
    150"L x 47"W x 63"H (3800x1200x1600)    
Crated Weight:   
   2865 lbs (1300kg)